Tool
Makita XPS01PTJ dust port: the 1-7/16 in label
Makita's XPS01PTJ page describes a large 1-7/16 in rear dust port but does not say whether that is an inside or outside diameter.
Also listed as XPS01PTJ, XPS01
Short answer
Makita's XPS01PTJ page describes a large 1-7/16-inch rear dust port. It does not say whether the figure is an inside or outside diameter, and it names no hose or adapter. The corded SP6000J page uses the same label but also says 1-1/2 in OD, so measure before you buy.
Key facts
- Tool type
- Cordless plunge circular saw (Makita)[1]
- Dust port size (maker's label)
- Makita: 'large 1-7/16-inch rear dust port'[1]
- Inside or outside diameter
- Not confirmedMakita does not say whether 1-7/16 in is an ID or an OD.
- Maker's own extractor connection
- Not confirmed
- Maker's route to other vacuums
- Not confirmed
- Adapters the maker names
- Not confirmed
- Hoses the maker lists
- Not confirmed
- Dust parts in the box
- Not confirmed
- Look-alike parts that are not hose parts
- Not confirmed
- Not confirmed
- Not confirmed
Watch out for
- The 1-7/16 in label matches the corded SP6000J page, but Makita does not say whether either figure is an ID or an OD, so the two ports are not confirmed to match.