Cable setup
Body-Solid SPRFT for SPR1000: cables, connectors and parts rules
The two cable lengths in Body-Solid's SPRFT manual, the connector parts it lists, and the manual's rules on checks, replacement parts and attachments.
Also listed as Body-Solid SPRFT, SPRFT, SPR1000 functional trainer kit
Short answer
Body-Solid's manual for the Functional Trainer Kit for SPR1000 (SPRFT) lists a 9300 mm top cable and a 5875 mm low cable, which are different parts. It tells owners to check the unit and its cables before each use, to use only Body-Solid replacement parts, and not to use accessory attachments Body-Solid does not recommend.
Key facts
- Setup type
- Functional trainer kit for a rack[1]
- Racks or supports the maker lists
- Body-Solid SPR1000[1]
- Maker exclusions
- Not confirmed
- Mount and hardware
- Not confirmed
- Resistance and loading
- Not confirmed
- Pull ratio
- Not confirmed
- Maker's load rating
- No maximum load stated in the manual[1]
- Cable length and diameter
- Top cable (part 24) 9300 mm; low cable (part 25) 5875 mm[1]The manual does not say how length is measured or give a cable diameter.
- Cable travel
- Not confirmed
- What is included
- The parts list names a cable connector, an accessory connector, a cable connector bolt, a steel chain and a snap link as separate parts[1]
- Connector at the cable end
- A snap link and a steel chain are listed parts; the manual does not say where they attach[1]
- Small increments
- Not confirmed
- Installation the maker requires
- Check the unit and its cables before each use; make sure all fasteners and cables are secure and in good working condition[1]
- Maker warranty
- Non-Body-Solid parts could void the warranty[1]
- Replacement parts
- Body-Solid replacement parts only; return damaged or dropped equipment to a service center[1]
- Not confirmed
- No cable diameter, connector dimensions or ratings, or cable replacement interval in the manual[1]
Watch out for
- The top and low cables are different parts (9300 mm and 5875 mm) that run over different pulleys, so order a replacement by part number.
- Body-Solid says not to use accessory attachments it does not recommend, so no third-party kit is listed here.
- Check the unit and cables before each use, per the manual.
Questions
Are the SPRFT top and low cables the same?
No. The manual lists the top cable (part 24) at 9300 mm and the low cable (part 25) at 5875 mm, and the two run over different pulleys.[1]
Can I use non-Body-Solid parts on the SPRFT?
The manual says to use only Body-Solid replacement parts and warns that other parts could void the warranty. It also says to return damaged or dropped equipment to a service center.[1]
How often should I check the SPRFT cables?
Body-Solid's manual says to check the unit and its cables before each use. It gives no replacement interval.[1]